المستودع الرقمي لـقسم الكيمياء

In this study, six residents of Zawia City who had no history record of occupational lead exposure were investigated. One sample of venous blood was collected from each. Sample preparation consisted of a simple dilution (twenty-fold) with 0.15N HNO3. The was centrifuged to separate serum, which was then isolated and analyzed for lead content by Flame Atomic Absorption Spectroscopy (FAAS). The residue of the sample was also analyzed by the same technique for blood level. The blood lead level in the residue was higher than that in serum lead level. Mean lead concentrations were 4.48mg/L in serum and 60.23 mg/L in residual blood respectively. Blood lead level was quietly correlated with serum lead and accounted for 95% of the variability of serum lead concentration. The bivariate regression coefficient of serum lead was 0.221 (p. 0.001). In a multivariate regression model of serum lead levels that include blood and serum lead level remained an independent predictor of lead plasma level (p. 0.007, p
Ragiab Ali Mokhtar Issa(2-2018)

Ternary systems of 152Eu(III), bulk bentonite and ethylenediaminetetraacetic acid (EDTA) ([Eu] = 7.9 × 10−10 M; pH = 6.0–7.0) have been studied. Without EDTA, there was slow uptake in a two-stage process, with initial rapid sorption of Eu(III) (96%), followed by slower uptake of a much smaller fraction (3.0% over a period of one month). The reversibility of Eu(III) binding was tested by allowing Eu(III) to sorb to bentonite for 1–322 days. EDTA was added to the pre-equilibrated Eu bentonite systems at 0.01 M, a concentration that was sufficient to suppress sorption in a system where EDTA was present prior to the contact of Eu(III) with bentonite. A fraction of the Eu was released instantaneously (30‒50%), but a significant amount remained bound. With time, the amount of Eu(III) retained by the bentonite reduced, with a slow fraction dissociation rate constant of approximately 4.3 × 10−8 s−1 (values in the range 2.2 × 10−8 – 1.0 × 10−7 s−1) for pre-equilibration times ≥7 days. Eventually, the amount of Eu(III) remaining bound to the bentonite was within error of that when EDTA was present prior to contact (4.5% ± 0.6), although in systems with pre-equilibration times >100 days, full release took up to 500 days. Europium interactions with colloidal bentonitewere also studied, and the dissociation rate constant measured by a resin competition method. For the colloids, more Eu was found in the slowly dissociating fraction (60–70%), but the first-order dissociation rate constant was faster, with an average rate constant of 8.8 × 10−7 s−1 and a range of 7.7 × 10−7–9.5 × 10−7 s−1. For both bulk and colloidal bentonite, although slow dissociation was observed for Eu(III), there was no convincing evidence for ‘irreversible’ binding.
RAGIAB ISSA(1-2021)

Thirteen Olive oil samples were collected from five different places in the western Libyan region with different cultivation periods. The physical and chemical properties of samples were investigated and classified whether they comply with the Libyan standard specification number 8/2002 or not. The density and refractive index of almost all samples were found within the normal range (0.908-0.919) and (1.4688-1.4705) respectively whereas the chemical properties showed a range of fluctuated values such as peroxide number (11.20-60.40), acidity value (0.737-17.94), saponification number (185.34-199.65), esterification number (173.84-194.36) and iodine number (71.00-94.10). A third of the investigated samples are considered to be of good quality mainly the newer samples
Ragiab A. M. Issa(9-2017)

The thermovoltaic detection (TVD) technique is based on measurement of the EMF generated by two dissimilar metal electrodes in contact with the specimen. This technique has recently been applied when investigating different types of materials involving thermal decomposition reactions which have more normally been studied by conventional thermal analysis techniques, such as DTA, TG, etc. This paper reports the application of the combined TVD and DTA techniques for thermal characterization of materials. The Harrop DTA system has been modified such that measurements by the two techniques can be made simultaneously in the same environment. Data have been obtained on different types of materials, e.g., NiSO,.6H,O and CoSO,.7H,O, etc., at a programmed heating rate of 10” C rnin- ‘. Results obtained by these techniques are discussed and compared with the corresponding values in the literature.
Ragiab Ali Mokhtar(5-1990)

In this study 10 guaianolide-type sesquiterpene g-lactones named amphoricarpolides, isolated from the aerial parts of two endemic subspecies of Amphoricarpos neumayeri (ssp. neumayeri and ssp. murbeckii Bošnjak), were investigated by means of reversed-phase thin-layer chromatography. Methanol–water and tetrahydrofuran–water binary mixtures were used as mobile phase in order to determine lipophilicity parameters RM0 and C0. Some of the investigated compounds were screened for their cytotoxic activity against HeLa and B16 cells. Chromatographically obtained lipophilicity parameters were correlated with calculated logP values and IC50 values. Principal component analysis identified the dominant pattern in the chromatographically obtained data.
ABUBAKER A BASHIR ATRROG(9-2008)

أجري هذا البحث لتقدير فيتامين C في العصائر الطازجة لبعض عينات الليمون والبرتقال المحلي. وتم تقدير تركيزالفيتامين بطريقة المعايرة باستخدام محلول اليود القياسي وأظهرنتائج هذا البحث أن كمية الفيتامين تختلف باختلاف العينة وحتى في عينات نفس النوع، حيث وجد أن تركيز فيتامين C بوحدة ملغ\100مل لعينتين من نفس النوعللبرتقال الدمي (37 و 76) وبرتقال أبو سرة (33 و 64) وللبرتقال الحلو (28 و 40) ولليوسفي (17 و 28) وللبرتقال المر (24.7 و 48) وللبرتقال الحامض (31 و 58) ولليمون (21 و 41) وأعلى تركيز كان لعينة البرتقال الدمي وأقل تركيز كان لعينة الليمون.
رجب علي المختار عيسى(1-2021)

In most cases dietary supplements especially in Libya are consumed without prescriptions and the public has very limited any awareness of their health risk. The lack of quality control on numerous brands of dietary supplements in pharmacies of Libya today may result in a serious health problem. The aim of this study is to determine the iron content using a fast and accurate method for quality control of some imported dietary supplements, based on spectrophotometric measurement of iron after complexation with 1, 10-phenanthroline in an acidic medium. Eight types of vitamin supplementary tablets were randomly collected from the Libyan market and analyzed for the iron content. The analysis showed an average value of 61mg Fe/pill for the range of 40.07-112.63 mg Fe/pill. Results showed that 75% of the samples were lower in iron content than that recorded on the dietary products.
Ragiab A. M. Issa(4-2020)

This report is based on the assessment of four heavy metals: lead, chromium, nickel, and copper, in thirty-two roadside soil samples, one of which was a virgin soil, in Zawia City, Libya. During spring 2019, soil samples were collected from five sites along Jamal Street starting from the old university building to Al-Shuhadaa Square. The atomic absorption spectrometer Perkin Elmer AAnalyst 400 was used in this study using absorption mode, except for the use of Cu emission mode due to the unavailability of the Cu lamp. Results showed that the highest concentrations of the investigated elements were: 36 mg/kg for Pb, 15.6 mg/kg for Cr, 8.3 mg/kg for Ni, and 50 mg/kg for Cu. These values are in agreement with the allowable values of heavy metal concentration of soils in some European countries (i.e. Austria, Germany, and France). However, the concentration values for Pb, Cr, Ni, and Cu were 5.2, 2.9, 2.3, and 7.8 fold higher, respectively, than that of the virgin soil sample collected about 10 km away from the city centre. The sample preparation method used in this work was demonstrated to be suitable, showing acceptable recovery values (R%) of 94.6%, 81.9%, 87.6%, and 90.7% for Pb, Cr, Ni, and Cu, respectively.
Ragiab A M Issa(4-2020)